Patna’s water poses unique challenges to maintaining silky, frizz-free hair. Minerals, chlorine, and fluctuating pH levels can all interfere with a keratin treatment in Patna, leaving them disappointed when their smooth look fails to last as long as expected. The catch is that many of these issues are preventable if you possess information regarding the common mistakes to avoid.
Provided you pay attention to how your hair reacts with indigenous water, you can prolong the life of your treatment as well as the general health of your hair.
1. Ignoring Water Hardness
Hard water containing high levels of calcium and magnesium is one of the most significant issues in Patna. If you shampoo treated hair with hard water, minerals get deposited on the surface, reducing the shine and degrading the keratin seal. This ultimately leads to frizz and reduced smoothness.
Solution: Set up a shower filter or a water softener if possible. Use a clarifying or chelating shampoo once a month to remove mineral deposits.
2. Washing Hair Too Soon
Following keratin or hair rebonding in Patna, the cuticle must have time to settle and seal in the treatment. If you wash your hair too soon, especially if you are using untreated water, you may wash the keratin coating off before the keratin has completely bonded.
The solution: If it is doable, it most certainly will be the best decision to adhere to the recommendation of the salon to wait a minimum of 48 to 72 hours before the first wash. If it absolutely had to happen, you should rinse your hair with bottled or filtered water rather than using tap water, which is not treated.
3. Overlooking Chlorine Exposure
Patna water supply typically contains chlorine, which can damage newly treated hair. Chlorine breaks down the keratin layer and leads to one-sided effects, i.e., patchiness and dryness.
Solution: Limit direct exposure to chlorinated water, particularly during the first week. For added protection, shampoo hair in filtered water prior to and after swimming, and spray a protective conditioner or serum.
4. Using Harsh Products Following Treatment
Another frequent error is the use of sulfates or high salt shampoos and conditioners. These remove the keratin layer and cause the treatment to wear off more quickly. Combined with bad water quality, this can drastically reduce the life of your treatment.
Solution: Use sulfate-free and keratin-safe products at all times. They preserve the efficacy of the treatment and shield hair from complex water effects.
5. Disregarding pH Balance
The water of Patna is not always ideal for post-treatment hair. Alkaline water makes the cuticle lift, and keratin will be able to escape from it. Very acidic water will cause dryness and stiffness.
Solution: Use after-care products that are formulated to bring the hair’s natural pH balance back into place. Some keratin-friendly conditioners and leave-ins are formulated to close cuticles and maintain silky hair.
Conclusion
Avoiding these common mistakes can be the make-or-break for the success or failure of the duration of your keratin treatment in Patna.
For the best treatment and expert advice, trust Beauty Island. Their specialists not only flawlessly execute keratin treatments and rebonding, but they also provide you with information on how to maintain those results regardless of the local water quality.
